![]() ![]() You will be asked to enter a new password and then confirm it. Do this with the following command: usermod -l newusername oldusernameĪlternatively, change the password with: passwd newusername You can go ahead and update system packages with: pacman -Syu Now complete the installation by launching the keyring pacman and entering the Arch Linux ARM package signing keys with: pacman-key -init pacman-key -populate archlinuxarm Now run the following command: wifi-menuĪ menu will load and you can choose your WiFi network, then log in. The username for this account is root and the password is also root. To connect over WiFi, first log in with the default root account. You will need an Internet connection via an Ethernet cable or WiFi network. Insert the SD card into the Raspberry Pi.Īfter inserting the SD card into the Raspberry Pi, go ahead and enable it. You can unmount two partitions using: unmount boot root The boot files will need to be moved to the boot partition of the SD card with: sudo mv root/boot/* boot Now, put the Arch Linux file you downloaded into the home directory and extract it to the root directory of the SD card with the following command: sudo bsdtar -xpf -C root sync sudo mkfs.vfat /dev/sdb1 sudo mkdir boot sudo mount /dev/sdb1 boot sudo mkfs.ext4 /dev/sdb2 sudo mkdir root sudo mount /dev/sdb2 root Remember to replace the partition name in these commands with your partition name. Do this with the following series of commands. Next, the boot and root partitions need to be mounted. In our case, the partitions are / dev / sdb1 and / dev / sdb2. The SD card will show up and you will be able to see the partitions. To list your partitions, type the following: sudo fdisk -l You need to mount FAT & ext4 file system. Write the partition table and exit fdisk by typing w. Press Enter twice to accept the default settings for the first and last sectors. Type n, followed by p, then enter 2 to create the root partition. Type t into the Command Prompt, then c to set the first partition as type W95 FAT32 (LBA). When prompted for the last sector, type + 100M and press Enter. You will need to press the Enter button after this sequence to continue. p stands for primary (primary) and 1 stands for the first partition on the drive. If there are no more partitions left, go ahead and create a boot partition by typing n, then p, followed by 1 into Terminal. Type p into Terminal to check if there are any partitions left. To do this, type o and press Enter in Terminal. You will need to delete any existing partitions on the drive. To do this run the following command, note that you will need to replace / dev / sdc with the name of your SD card: sudo fdisk /dev/sdc The SD card that we are using is / dev / sdc. Make a list of all storage devices attached to the machine Do this with the following command: sudo fdisk -l ![]() First, you will need to make a list of the storage devices attached to your device to determine which device is the SD card. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |